量產型燒錄器

  • 新一代高速核心,搭配USB3.0傳輸介面,燒錄速度大幅提升
  • ALL-300G2針對eMMC, NAND等大容量IC的燒錄速度比ALL-200G快3倍
  • 最多可支援16個燒錄座
  • 支援各種類IC的萬用型燒錄器

Universal Device Programmer

 A new generation compact size high performance device programmer

Introduction

ALL-200 Universal Device Programmer is designed to provide high quality yet compact size programming platform for IC programming at development / engineering stage.

 

ALL-200 extremely high freq. core circuit design significantly cut down programming time of high density memory products.

 

ALL-200 has 56 sets of Precise Universal Pin Driver to provide high speed, low noise, accurate and reliable programming signals for various IC products including high speed low power devices recently released to market.

 

ALL-200 works with dedicated Socket Board (HD-xxx-xxx) per IC package type. This eliminates the requirement of additional socket adaptor / converter which might impact programming yield due to poor contact and/or signal noise.

 

The supporting software is updated weekly on HI-LO web site for checking / retrieving through Internet. Programming of new products will not be neglected after purchasing.

Gang Device Programmer

A multi-site high performance IC device programmer

 

Introduction

ALL-200G Gang Device Programmer is designed to provide high quality programming platform for new released IC products on the market especially for high density FLASH units. ALL-200G works with multiple Socket Boards to perform multi-site programming for limited / mass production. Through USB port, 4/8 sets of ALL-200G can be connected to one PC for either synchronous or asynchronous multi-site programming to maximize production capacity.

 

ALL-200G extremely high freq. core circuit design significantly cut down programming time of high density memory products.

ALL-200G Device Programmer has 56 x 8 sets of Precise Universal Pin Driver to provide high speed, low noise, accurate and reliable programming signals for various IC products including high speed low power devices recently released to market. Each site owns individual Pin Driver so sites are totally independent without interfering each other during multi-site programming.

 

ALL-200G can be setup for multi-site operation when production required. Up to 8 sites x 8 sets = 64 sites can be programmed simultaneously to maximize production. For more to go, the ALL-200G based Automated Programming System, AT3-300 Series, can serve the requirement.

 

The supporting software is updated weekly on HI-LO web site for checking / retrieving through Internet easily. Programming of new products will not be neglected after purchasing.

Device Programmers

Automated Programming Systems

Download AT3-300D

Go to top